Not so Good
Verified Buyer -
Ignition caps came off once the engine started running. The rubber part fit tight when cold but come off completley when hot. The metal contacts were too small for the towers so they just popped right out. This is going on a Ford 302 V 6.This is not a good fit for my application.
Bottom Line No, I would not recommend to a friend
GREAT PRODUCT CLEAN PROFFESIONAL LOOK
Verified Buyer -
I see people complining the have to cut and crimp. well ibought these and the crimper and if you follow directions they look awsome are very easy to install and make look great they also include extra ends in case you mess up . so if you want a clean look and you have a little common sense and mechanical knowhow these are the wires for you..
Bottom Line No, I would not recommend to a friend
Not the correct set for my vehicle
Verified Buyer -
Set comes with 2 types of right angle distributor-side boots. If the set is going to be a universal fits all set, then it should also come with straight boots. Not thoroughly impressed as I’d hoped to be.
Bottom Line No, I would not recommend to a friend
Not for 70 Buick, Non-HEI
I needed a new set of plug wires for my car. These were listed as "Exact Fit" for my 1970 Buick Gran Sport Stage 1 455 but they are for 75 and newer HEI distributor ends with the tower type terminals with integrated coil. I needed the old press-in ends for the old points type distributor cap with a coil wire. This was not listed any where on the description of the product online. I'll will try to exchange them at the store. This would have been instantly obvious in person but the description failed me.
Bottom Line No, I would not recommend to a friend
Great
Verified Buyer -
Great